Page 1 of 1

How to put water in building's textures

Posted: Sat Jan 12, 2019 19:18
by TheRetroGuy
You may have asked yourself "How do I put water in my building?". Well, I got your answer! It only works for the ground tough so if you make a skyscraper and attempting to make water in it, well, you will need to make your own.

Let's start!

First, make your building. After, when coloring, make sure to know where It will be and that it is on the tile and not over the tile, or if you wanna say, don't make it above the square that defines the size of your building, like this:
6760966635535529984.png (1015 Bytes) Viewed 5482 times
After, trace the outside of your water. And finally, erase the inside, where you wanted the water to be. Keep it blank.
Now, you should have water. But be sure to turn off drawground.

Re: How to put water in building's textures

Posted: Fri Feb 08, 2019 4:58
by CommanderABab